View Single Post
Old Jul 04, 2010, 09:39 PM
RCvertt is offline
Find More Posts by RCvertt
Registered User
RCvertt's Avatar
Joined Aug 2007
4,535 Posts
I got it off the ground today.
Is there a way to decrease the yaw gyros sensitivity to vibrations?

Quote:
Originally Posted by Alexinparis View Post
Motor shutdown
Motor shutdown is done by tilting the yaw stick left while having the throttle stick in minimum position.
Mine shuts down with yaw stick right while having the throttle stick at the minimum position.

My opposite rudder commands seam to be due to the way I have my servo mounted.

Quote:
Originally Posted by Alexinparis View Post
Gyroscopes calibration. To calibrate the neutral of gyroscopes, you must tilt the yaw stick left, tilt the pitch stick down while having the throttle stick in minimal position..
Doing this arms my motors and makes them spin. Is this supposed to happend during calibration?

Yaw stick right, pitch stick down, throttle down, makes the green led flash three times then it goes out. This isn't calibration right? It seams to set the tri into PID value setting mode?
RCvertt is offline Find More Posts by RCvertt
Last edited by RCvertt; Jul 05, 2010 at 12:25 AM.
Reply With Quote