Thread: Build Log Carbon Sally "Thepasty"
View Single Post
Old Jul 03, 2010, 05:17 PM
johannlochner is offline
Find More Posts by johannlochner
Stirring the pot
johannlochner's Avatar
Port Elizabeth South Africa
Joined Jun 2008
4,033 Posts
We're Still here!
The going is a bit slow...
The replacement of the vacuum compressor still in progress..
the kids are on school holiday
And...
Way to many soccer matches to watch!

On Steve's latest plan, it shows the tip of the tail (leading edge) about centre of the wing.
I don't want to notch the wing more than a 1/3 rd from the trailing edge for strength. as it is seated on the one piece fuz.
I gave the fin more body profile towards the front for weight and surface area.
The fin is now very thin...
I hope it will be even and level on the splitting board!
Sanding down the wing and filling for painting.
Couple more coats needed on the plug..
And we should be ready to go!
johannlochner is offline Find More Posts by johannlochner
Reply With Quote