View Single Post
Old Nov 29, 2003, 11:47 AM
RCWorks is offline
Find More Posts by RCWorks
Registered User
RCWorks's Avatar
Joined Aug 2003
1,983 Posts
I want to use an DD 020 but I do not have one. Nor an 010...

I am going to try my Zagi Pusher and KAN 1050s for this one.

If I like it I will try going from the 20 inch span to a 30inch and go to my Jeti 15/4 and 8 cells of CP-1300

This one is made from a 20x30 sheet of black sturdyboard.

If I get to a 30 inch verstion with the brushless I will add the cockpit in EPS as well as the top engine nacells and landing gear. If I use the Jeti I will be using a 7x4 prop

The 20 inch-speed 400 setup I will start with a 6x4.

If I can get a good supply of depron I would consider useing a GWS 350 C drive and an MP Jet on a 90x70 on a 30 incher

Someone I fly with was suggesting that I stick the wattage turbofan with the astro in between the stiffeners.

There are a lot of choices... but I have speed 400s, cobalts, grapner 480s, KAN1050s and CP1300s on hand

Since I got a 3 pack of the sturdy board I can play with the design.

I am open to other suggestions...
RCWorks is offline Find More Posts by RCWorks
RCG Plus Member