View Single Post
Old Jun 30, 2010, 05:06 PM
kapteinkuk is offline
Find More Posts by kapteinkuk
Quad Whisperer
Joined Jul 2008
953 Posts
Quote:
Originally Posted by DarkHeli View Post
Okay, we may be getting somewhere...

I plugged in my bec to RX OUT ports, and I get a green light, but it doesn't turn off. Voltage at the chip reads about 2 Volts. If I plug the bec into the ESC/motor out ports, I get no power to the chip and no light.

Perhaps I have a jumper wire not fully soldered, and not supplying power to the other half of board?
you have to check it out completely
kapteinkuk is offline Find More Posts by kapteinkuk
Reply With Quote