View Single Post
Old Jun 30, 2010, 02:45 PM
DarkHeli is offline
Find More Posts by DarkHeli
Future-proof EVERYTHING
DarkHeli's Avatar
NY
Joined Jul 2008
762 Posts
Okay, we may be getting somewhere...

I plugged in my bec to RX OUT ports, and I get a green light, but it doesn't turn off. Voltage at the chip reads about 2 Volts. If I plug the bec into the ESC/motor out ports, I get no power to the chip and no light.

Perhaps I have a jumper wire not fully soldered, and not supplying power to the other half of board?
DarkHeli is offline Find More Posts by DarkHeli
Reply With Quote