View Single Post
Old Jun 28, 2010, 11:46 AM
Prime_8 is offline
Find More Posts by Prime_8
Lawn dart pilot/builder
Prime_8's Avatar
N.L. Canada
Joined Jun 2010
2,337 Posts
Ok the update SNice was looking for ... booms, shaped and temp tacked in
place with hot glue ( epoxy later ).

Yep it is sitting on it's tail surfaces in the 2nd shot . They are very strong .
the pink foam is very strong over short distnaces . add soem wood and very strong .

it floats / glides with still a touch of nose heavy .

I may not add a active rear elivator , only a trim surface. (still pondering that one ) Leaving picth the canards, but that means less pitch controll at low speeds , so prolly not.
Prime_8 is offline Find More Posts by Prime_8
Reply With Quote