: New Product
Sneak Peek at the NEW Cellpro PowerLab 8 (v2)
View Single Post
Jun 27, 2010
, 09:14 AM
Haralson County GA. USA
Joined Oct 2004
Operating in Pri / Exp. mode 1 3S 2200 and 1 4S 3300 being charged at Auto 3C Preset # 1 ,1 minute into the charge.
Addational attachements added during charge.
Note : The Auto 3C charge selected was being limited to a Max. of 6A due to a default setting under the Fuel Tab. I will increase this to 10A and 3C should run much faster.
Everytime we have a firmware revesion it seems to take me days to get all of my settings back to where I had them. Sometimes I do not bother to change them so that I am running the defaults that others will be using. This is one example that can cause confusion.
View all Images in thread
Cells (packs) 23 min. into Auto 3C charge
Power supply screen 20 min. into charge
End of Auto 3c charge one 3S 2200 and one 4S 3300
Auto C 6A max. default
Auto C amp. increased to 10A and close to 3C rate achived.
Auto 3C with Max. Auto increased to 10A.
Last edited by everydayflyer; Jun 27, 2010 at