Thread: Build Log EPP Foam Sloroller 3D Biplane
View Single Post
Old Jun 20, 2010, 05:43 PM
amigo is offline
Find More Posts by amigo
Roll Tide!
Joined Oct 2005
325 Posts
Hi Thanos, I used pretty much the same set-up as you. I use this motor with a GWS curved 8043 prop, a 10 amp esc and a 3s 460mAh rhino:

http://www.headsuprc.com/servlet/the...lectric/Detail

I used .047 carbon rods for pushrods. I get about 4 minutes of pure hover and the motor gets a little hot. I get up to 10 minutes of easy flying and the motor gets a little warm. So I don't know what to suggest. Maybe depron is much heavier than 9mm 1.3# EPP.

My AUW with the 3s 460mAh rhino is 8.34 oz. Best of luck!
amigo is offline Find More Posts by amigo
Reply With Quote