View Single Post
Old Jun 15, 2010, 10:24 PM
Parkflying is online now
Find More Posts by Parkflying
United States, MI, Auburn Hills
Joined Dec 2008
1,087 Posts
Quote:
Originally Posted by morgusmax View Post
i'm interested in this as well - i can't get the motor to come on! is there a particular order to plug the motor wires into the esc? the motor wires are red, blue, yellow, but the esc has no such designation!
You have to reset the ESC for the Throttle end points. Also the motor wires do have a correct order to plug into the ESC

Try these:

Blue to A on ESC
Red to C on ESC
Yellow to B on ESC

To reset the ESC for the Throttle of your new receiver:
Connect your channel 3 of the receiver to the plug on the ESC
With the throttle at lowest setting plug in the battery to the ESC

The ESC should beep and then play a short tune; if the ESC beeps
contentiously for longer then 30 seconds follow the instructions below.

Sometimes when connecting a new ESC to a receiver,
we must reset the ESC so it knows the top end and bottom end
of the throttle control.
These steps are easy.

Leave the throttle trim tab at bottom like you normally use it.

Throttle range setting:
1. Switch on transmitter, move throttle stick to top
2. Connect battery pack to ESC, and wait for about 2 seconds
"Beep-Beep-" tone should be emitted, means throttle range highest point has been correctly confirmed
3. Move throttle stick to the bottom, several "beep-" tones should be emitted, presenting the number of battery cells
A long "Beep-" tone should be emitted, means throttle range lowest point has been correctly confirmed
4. You should be ready to test fly.


Hope this helps

Max
Parkflying is online now Find More Posts by Parkflying
Site Sponsor
Reply With Quote