Thread: Discussion X32
View Single Post
Old Jun 12, 2010, 10:26 PM
AirX is offline
Find More Posts by AirX
EDF rules... :)
AirX's Avatar
Joined Nov 1999
13,848 Posts
Hi Matt,

Thanks for posting that bit of inspiration....

I am progressing a bit, I cut the templates for mine today. I wanted to cut it on the CNC but since I will post the templates to this thread not everyone would be using a CNC to cut thiers so I wanted to verify the templates worked correctly...

Eric B.
AirX is offline Find More Posts by AirX