View Single Post
Old Dec 09, 2001, 01:58 PM
hoser is offline
Find More Posts by hoser
shut up & fly
hoser's Avatar
United States, FL, Miami
Joined May 2001
3,918 Posts
I have had similar encounters with that also. even on the midi fan.

what I've done is sand the inside of the fan where the motor sits. put in one finger with coarse paper in the area where the motor goes and sand till it slips in.

I have also been thinking of cutting 1/4" slits between each of the stators all the way to the motor mount are where the screws go to help in cooling, I doubt that that would cause any structural damage to the fan.
hoser is offline Find More Posts by hoser
Reply With Quote