View Single Post
Old May 16, 2010, 09:52 PM
crd is offline
crd
Find More Posts by crd
crd
Always thinkering
crd's Avatar
United States, FL
Joined Nov 2006
1,267 Posts
Success

Thanks Guizmo for the info, I just soldered the HT signal wire to the corresponding joint in the board and got the 12v power from the RX module pins. it works perfectly so far, at least now the HT shows movement on the servo display on the radio, I just need to hook up my spektrum module and my 5ch receiver ans see if it works with my pan tilt pod. ( I need to use ch4 and ch5 on my radio instead of 5 and 6 because I only have a 5ch RX for now.)

here is what I did

Turnigy X9 and Hobby King XGY-1000 head tracker (0 min 34 sec)
crd is offline Find More Posts by crd
RCG Plus Member
Reply With Quote