View Single Post
Old May 02, 2010, 02:07 PM
JussiH is offline
Find More Posts by JussiH
Friend is a 4 letter word...
JussiH's Avatar
3rd stone from the sun
Joined May 2007
2,679 Posts

Very nice work with that SMD design.....are you going to make a production of those boards? Nice idea to use recycled components from silver "gyrds"...

Ive redesigned my board as well. But I made it 52 by 52 get 2mm clearance from mounting holes to edge of board. Mounting holes are 45 mm apart.....

There is now both a singlesided and a 2-sided design with ISP. I will add the files to original post in a bit.

I am still up for a limited production-run of these boards....but I personally think that Kapteins SMD-board makes more sense (lighter, smaller, cheaper components), and I would use that if it were to be produced.

Of course the SMD-soldering could be a problem for some - so perhaps there is still a need for a TH board.....let me know if you still want one.
JussiH is offline Find More Posts by JussiH
RCG Plus Member
Last edited by JussiH; May 02, 2010 at 02:59 PM.
Reply With Quote