HobbyTopGun L-39 by EJF.com
View Single Post
May 02, 2010
, 12:34 AM
wannabe Jet guy
Green Valley, AZ
Joined Aug 2004
I tried to get a good picture of the Horizontal and Vertical stab to show the channel, you end up with about a 1/4 inch tunnel to run wires.
Next up, the wing, glue your four spars to make two spars, then you have to find three other pieces that also go in the wing. Try to glue your two wing half's together with the two spars at the same time since they will help you keep the wing half's close to each other. PLEASE NOTE: THE FRONT SPAR HAS BEEN CHANGED. SEE THE LAST PICTURE.
View all Images in thread
Two main wing spar joiners, Glue two pieces together to make two spars out of the four pieces. I also glued to Rocket Pod Launcher while I had the Glue at hand.
parts needed to make the wing one piece
three pieces go in the top of the wing. the Two wing spars and the forward wing hold down. One of the spars from this picture has been changed, Please see the last Picture
Fitted flush as they should be glue
The bottom part of the wing gets the two wing mounting screw supports.
Servo packet/tunnel between the Vertical and horizontal stab
Notice how the front spar is like a U shaped. This is the correct forward spar for this wing.
Last edited by CRCJA; May 18, 2010 at
. Reason: Changed the Picture of the Wing Spar.