View Single Post
Old Apr 29, 2010, 08:54 PM
nanobot9000 is offline
Find More Posts by nanobot9000
Registered User
nanobot9000's Avatar
Pennsylvania
Joined Nov 2008
247 Posts
Question about a different motor design option - microQuad

First of all this has been a very informative and well done project which is why I am posting my question here. I like the idea that the part count is low and especially the move towards an SMD board. I had emailed Rolf asking about using pager type motors and small CW/CCW props from indoorflyer to make a palm sized quad and am seeking additional input. I have seen other posts of small quads smarty and others, but the details on the designs are either hard to locate or not complete as far as the programming - perhaps I am not looking in the correct place I would like to know if it would be possible to to adapt this design to use non-esc motors like small pager motors?

Thanks,
Mike
nanobot9000 is offline Find More Posts by nanobot9000
Reply With Quote