Thread: Discussion Futaba 8FG(S)
View Single Post
Old Apr 28, 2010, 09:09 AM
Bax is offline
Find More Posts by Bax
Registered User
Central Illinois
Joined May 2003
295 Posts
The easiest way to set up butterfly is to ignore the butterfly mixer. Go into the Linkage Menu and then the Function section. Dial down to V1. By default, it should be set to "Camber". If not, set it to camber and then put it on the slider/stick/knob/switch you desire to use. Now, go into the Model Menu and then the Camber Mix. Turn it on and now you have a place to adjust the amount and direction of flaps, ailerons, and elevators when you move the desired control. Because you can adjust the direction of movement for each of the different channels you use, you can set up flaps, aileron droop, full butterfly (or "crow"), all with elevator compensation.
Bax is offline Find More Posts by Bax
Reply With Quote