View Single Post
Old Apr 24, 2010, 05:15 PM
MikeMayberry is offline
Find More Posts by MikeMayberry
Hitec/Multiplex USA
MikeMayberry's Avatar
Poway, California, United States
Joined Sep 2000
4,212 Posts
I think the problem here is the "L" and "H" (Low/High) as #2 is low which means that is the starting point so there is no elev mixing (see graph) but you have elev mixing in #1 and #0. This is the same with the sliders as the low position in neutral flap and you have to move it up to get the flaps to deploy. This is something we as asked to be swapped in a firmware update so that the top position is neutral and you move them down for activation. The way it is now the switch will be down at neutral and you'll have to move it up to deploy flaps. You can still set them where ever you want in the menu, again... refer to the graph and the line which will be far left (L), center, and far right (H).

You could also use one of the point curve (6-8) P-mixes as a work around too.

Mike.
MikeMayberry is offline Find More Posts by MikeMayberry
Reply With Quote