View Single Post
Old Apr 23, 2010, 09:38 PM
MikeMayberry is offline
Find More Posts by MikeMayberry
Hitec/Multiplex USA
MikeMayberry's Avatar
Poway, California, United States
Joined Sep 2000
4,212 Posts
Quote:
Originally Posted by RCFlyer55 View Post
This may not be classified as a "wish" as much as a "please fix"

I think I found a glitch in the programming of Flap to Elev mixing.

I selected "E" a 3 position switch in "FLP CON" mix
POS 0 is all the way back or my no flaps position I CAN mix Elev in this position (but would have no reason too).
POS 1 is the middle position I can mix Elev in this position, and did
POS 2 forward position, or my FULL flaps I CAN NOT mix Elev in this position, but wanted too

So I used P-Mix to make this short
POS 0 = OFF (didn't try to mis anything in this position because it "should" be off
POS 1 = ON WILL NOT MIX Elev in this position (but I wanted too)
POS 2 = ON WILL mix Elev in this position (and I did use it)

So I had to use BOTH P-Mix & "FLP CON" to mix the Elev in the two flap(switch) positions.

I also have Flaps, "FLP CON", and P-Mix all set to switch E.

Oh and setting up flaps on Switch E was a PITA. In order to get the 3 positions I wanted I had to use a combo of EPA, subtrim, and "FLP CON". I still don't even know how I got it to work and doubt I could do it again, and the Manual was of no help!
The first thing to do is assign the flap channel to a 3-pos switch. Then in FLAP COND use this same switch and then there is independent flap and elevator settings for each position of the switch.

Mike.
MikeMayberry is offline Find More Posts by MikeMayberry
Reply With Quote