View Single Post
Old Apr 14, 2010, 08:36 AM
scootty83 is offline
Find More Posts by scootty83
THAT'S WHAT SHE SAID!!!
scootty83's Avatar
Joined Aug 2009
84 Posts
I kind of fixed the motor. I took it apart and looked at both bearings. They both look fine. The one inside the bell is the one that sounds as if it 'might' have grinding in it possibly. I greased it and put it back together and I pushed the shaft back out the side it was originally on. I ran it up and it worked perfectly all the way up to full throttle and back down without any problems. After this, I pushed the shaft back out the other end, tested it, and the noise started almost immediately. Again, I pushed the shaft back to its original position, ran it up, and was perfectly fine again. Dunno whats going on with it. For now I am going to just leave it the way it is and put the prop adapter on the bell instead and use a folding prop I think.

Any more input from the pros would be great. THANKS ALL!
scootty83 is offline Find More Posts by scootty83
Reply With Quote