Thread: Discussion DragonOSD+V2 with RTH
View Single Post
Old Mar 31, 2010, 11:19 PM
barok is offline
Find More Posts by barok
Registered User
barok's Avatar
Joined Apr 2006
1,335 Posts
daniel..
ok so got everything wired up.. minus the current sensor and gps as they are still on route from usa.. able to see my video from the cam, when the dosd+ is powered.. i get a quick flash a split second (i'm assuming its the menu screen) then the battery voltage is show on the top corner.. i cannot get the on screen menu to appear...even assigned ch.5, on a 3way switch "e" (the only 3way switch in futaba 7c).. i'm sure i'm getting PPM signal on my hitec6 rx, cuz when i turn off the transmitter (Fut 7c) the servos would move back and forth..goin to failsafe getting signal from the Dosd+..

?or do i need the CS and GPS for the on screen to appear?
barok is offline Find More Posts by barok
Reply With Quote