Originally Posted by tjinguy
Nope I have "Set RPM" selected. I will check it again but that is the only way I set it up.
Should the motor hold exactly the same rpm until you lower throttle hold just the right amount, and then drop a little? What is a typical value for throttle hold in a DX7? I mean is it like 5% or is it much higher like in the 30s?
On a similar note ... if one actually did want to run "Gov High", how would you set up the auto bailout feature?
Oh the throttle hold calibration on my DX 7 & ICE 75 was at 10.5 but may be a little different for yours.