View Single Post
Old Mar 27, 2010, 11:54 AM
tjinguy is offline
Find More Posts by tjinguy
TJin(Guy + Tech)
tjinguy's Avatar
United States, NM, Socorro
Joined Jun 2008
784 Posts
Quote:
Originally Posted by RS Rogers View Post
It sounds as though you have either gov. low or gov. high selected on the Castle Link. The difference between the high & low gov. vs. set rpm is high & low will allow head speed changes with every point of throttle change. Set rpm has 1 speed for a set of ranges.

Steve
Nope I have "Set RPM" selected. I will check it again but that is the only way I set it up.

Should the motor hold exactly the same rpm until you lower throttle hold just the right amount, and then drop a little? What is a typical value for throttle hold in a DX7? I mean is it like 5% or is it much higher like in the 30s?

On a similar note ... if one actually did want to run "Gov High", how would you set up the auto bailout feature?
tjinguy is offline Find More Posts by tjinguy
Reply With Quote