View Single Post
Old Mar 27, 2010, 11:28 AM
RS Rogers is offline
Find More Posts by RS Rogers
Registered User
RS Rogers's Avatar
Clyde N.C.
Joined Oct 2003
527 Posts
Quote:
Originally Posted by tjinguy View Post
I have run into a snag setting up the auto bailout feature.

I selected the auto bailout feature and fixed endpoints. Then I set the end points on the radio. Next I set the normal curve to 0s and maxed out the throttle hold %. Next I spun the motor up in idle1 and started to lower the throttle hold value. The first click slowed the motor, as well as each additional click. The PDF states

"decrease the value pausing breifly between each point until you hear the motor loose power & begin to slow go no further!"

Well the instant I decrease it at all, the motor slows ... so what am I to take from that?
It sounds as though you have either gov. low or gov. high selected on the Castle Link. The difference between the high & low gov. vs. set rpm is high & low will allow head speed changes with every point of throttle change. Set rpm has 1 speed for a set of ranges.

Steve
RS Rogers is offline Find More Posts by RS Rogers
Reply With Quote