Thread: Discussion DragonOSD+V2 with RTH
View Single Post
Old Mar 27, 2010, 12:22 AM
Daniel Wee is offline
Find More Posts by Daniel Wee
Registered User
Joined Aug 2005
4,093 Posts
Yes, but this is a HUGE conjecture we are making. We are assuming that:-

1. The Berg4 and Berg7 use the same fundamental design
2. That they use the same MCU
3. That they use the same firmware
4. That the pin assignments are the same

I would feel a lot safer after verifying the signal with a scope (can you borrow one?). It would take only a minute to verify it on a scope. My advise is to do that before attempting to connecting anything as you risk damaging the receiver and the OSD. Having said that - the said pin 10 does not look like it is connected to power or ground so it could be a PWM pin, or a PPM pin if you are really lucky.

Daniel
Daniel Wee is offline Find More Posts by Daniel Wee
Reply With Quote