View Single Post
Old Mar 26, 2010, 06:46 PM
tjinguy is offline
Find More Posts by tjinguy
TJin(Guy + Tech)
tjinguy's Avatar
United States, NM, Socorro
Joined Jun 2008
784 Posts
I have run into a snag setting up the auto bailout feature.

I selected the auto bailout feature and fixed endpoints. Then I set the end points on the radio. Next I set the normal curve to 0s and maxed out the throttle hold %. Next I spun the motor up in idle1 and started to lower the throttle hold value. The first click slowed the motor, as well as each additional click. The PDF states

"decrease the value pausing breifly between each point until you hear the motor loose power & begin to slow go no further!"

Well the instant I decrease it at all, the motor slows ... so what am I to take from that?
tjinguy is offline Find More Posts by tjinguy
Reply With Quote