Thread: Discussion DragonOSD+V2 with RTH
View Single Post
Old Mar 25, 2010, 10:12 PM
galaxiex is offline
Find More Posts by galaxiex
my karma ranover my dogma
galaxiex's Avatar
Edmonton,Canada Eh
Joined Jun 2007
7,575 Posts
Ok, I just checked my current sensor and I am not getting any power on the red wire going to the OSD.

I have the Sparkfun C/S and I did the mod where you remove the 3 resistors.

I likely have screwed something up on the C/S board, tho I was very careful removing the resistors....

You guys may remember I am pretty good at soldering this tiny stuff....

John... I used the big Weller 120 Watt gun......

NOT!

(sorry John, I just had to throw that in there...)
galaxiex is offline Find More Posts by galaxiex
Reply With Quote