Thread: Mini-HowTo Solidworks Wing Mold
View Single Post
Old Mar 18, 2010, 03:41 PM
heli_bee is offline
Find More Posts by heli_bee
Registered User
Joined Mar 2005
501 Posts
Spot the error.

Hi all,

as promised see attached photo. The surface is actually a lot smoother than it looks. I stopped working on it when I realised it would take too long to put right. Actually, it would be more accurate to say it would take longer than I was prepared to spend on it.
heli_bee is offline Find More Posts by heli_bee
Reply With Quote