View Single Post
Old Mar 15, 2010, 07:13 PM
PLMS is offline
Find More Posts by PLMS
Martin - AKA mr.sneezy
PLMS's Avatar
Joined May 2004
1,702 Posts
Originally Posted by Extreme_RC View Post
Its SMA which is the annoying part, I have already asked them to supply an aerial the same as the HITEC one but to suit their modules.

John couldnt understand what I was on about but that photo is one I hadnt stumbled across, it shows exactly whats needed!

Chase can you please offer the above hitec style aerial as an option so us importers can have them available for the customer?

And to question the aerial design:
Wouldnt the fitting to the Tx be best to be the split pin shaft design which pushes into the FM aerial hole rather than sitting over the top? then you are guaranteed to fit most Tx's right?
Thanks for confirming it's SMA (EDIT: later post says it's actually RP-SMA). OK, then theres plan B. It's a little more messy but I'd have no hesitations to do it.
This option involves removing the original SMA socket from the TX module completely and plugging this other replacement antenna in instead.
The FrSky board should have an U.FL socket on it same as used by nearly all RC 2.4Ghz systems.
PLMS is offline Find More Posts by PLMS
Last edited by PLMS; Mar 17, 2010 at 08:16 PM.
Reply With Quote