View Single Post
Old Mar 15, 2010, 06:07 PM
Extreme_RC is offline
Find More Posts by Extreme_RC
Extreme CNC Alloy EDF
Extreme_RC's Avatar
Australia
Joined Mar 2006
11,987 Posts
Its SMA which is the annoying part, I have already asked them to supply an aerial the same as the HITEC one but to suit their modules.

John couldnt understand what I was on about but that photo is one I hadnt stumbled across, it shows exactly whats needed!

Chase can you please offer the above hitec style aerial as an option so us importers can have them available for the customer?

And to question the aerial design:
Wouldnt the fitting to the Tx be best to be the split pin shaft design which pushes into the FM aerial hole rather than sitting over the top? then you are guaranteed to fit most Tx's right?
Extreme_RC is offline Find More Posts by Extreme_RC
Last edited by Extreme_RC; Mar 15, 2010 at 06:12 PM.
Reply With Quote