Thread: Question Quanum 2.4ghz Telemetry
View Single Post
Old Mar 11, 2010, 06:36 PM
wcessna is offline
Find More Posts by wcessna
Yes my name is Cessna.
USA, FL, Tampa
Joined Mar 2010
253 Posts
I'll try. I went thru so many variations I am not completely confident of what the state was in #1. It had to be either what is below or just plainly powered up.

1) I had the receiver on and I had started it by holding the Bind button down and turning on the power.

As a result of the above the receiver started and said "Binding..." at the bottom of the screen.

2) I then picked up the transmitter. I push down the little button (next to the light and Antenna). While holding it down I inserted it in the battery.

At this point the green light started blinking and the voltage showed up.

If it that does nothing I would restart the reciever and not push the bind button. Let it power up. Then push the bind button. Let's hope for the best then.

Now I never have to deal with the button on the transmitter. If it is not seeing the transmitter I simply push the Bind button on the reciever and it says searching and then it pops up.
wcessna is offline Find More Posts by wcessna
Last edited by wcessna; Mar 11, 2010 at 07:07 PM.
Reply With Quote