Thread: Discussion New hyperion motors??
View Single Post
Old Feb 19, 2010, 03:00 PM
TROY01 is offline
Find More Posts by TROY01
Registered User
United States, CA, Corona
Joined Dec 2008
32 Posts
I am not bashing anything, I was just confused when I installed the prop and it did not turn the prop like I expected it would. I wanted the higher kv because I fugured that I could operate this at a higher speed than the cheaper motors and not burn it up. Thats why I ordered a -12 the invoice and box says -12 and that simply what I expected to see. It was not until I checked the KV that it was anything other than what I ordered.
Quote:
Originally Posted by Dylwad View Post
Also, You cant compare 2 motors just based on their amp draw on the same prop, you have to compare voltage and RPM too, or your just guessing that one is better than the other.

This happened early on when outrunners started showing up, Lots of people were comparing them to geared inrunners just based on the fact they pulled more amps on the same prop, what happened when they checked RPM was that the outrunners were pulling more amps and giving less RPM, so producing less usable power while using more power.

In other words, get a -12, and dont bash the -14 for not being a -12
TROY01 is offline Find More Posts by TROY01
Reply With Quote