View Single Post
Old Feb 15, 2010, 01:32 PM
modfly is offline
Find More Posts by modfly
Doing it in the Lateral Axis
modfly's Avatar
USA, OH, Akron
Joined Dec 2006
15,365 Posts
Mini-HowTo
How to add Flaps to the E-Flite UM 4-Site using the Dx6i radio

Note..These instructions are for the DX6i only.

I decided to do a separate thread on this topic as there is not much info out there on how to do this. I just added Flaps to my 4-Site and I will try to show how its done. Its more complicated than it first appears and I will be revising this thread as I go.

This thread will show how to make the aileron servos independent of each other and how to switch aileron modes also elevator mixing will be added.

There are two modes of operation as far as dual ailerons are concerned.
1. Channel 6 to reversed channel 2.
2. Reversed channel 2 to channel 6.

Mode 1 is the default and emulates 1 channel dual ailerons.
Mode 2 is used for 2 channel dual ailerons.

For the proper sequence of steps, goto page 3 post #42 Sorry but if I link Post #42 directly, it transposes some of the steps. Some kind of bug here @ rcgroups I guess. Its a very annoying bug and causes a lot of confusion I'm sure
modfly is offline Find More Posts by modfly
Last edited by modfly; Feb 18, 2010 at 03:20 PM.
Reply With Quote