View Single Post
Old Feb 13, 2010, 02:23 PM
ender707 is offline
Find More Posts by ender707
Registered User
ender707's Avatar
Sacramento, CA
Joined May 2009
718 Posts
Turnigy 2836 2350kv Outrunner

I have an additional mounting bracket from Gary at custumrcparts.com that I bought to try an outrunner with. Originally I thought that I would have to cut down the mount some to allow the outrunner to fit. I turned out that all I had to do was remove my 3.5mm bullet connectors and pass the motor wires through the cooling holes on the mount.

I have not yet flown this setup, but I do not think there will be any problems. Considering the difficulty of mounting this same outrunner to the Stock Stryker mount which made the mount much weaker, this was a piece of cake.
ender707 is offline Find More Posts by ender707
Last edited by ender707; Mar 16, 2010 at 02:48 AM.