View Single Post
Old Feb 12, 2010, 09:06 PM
Tommy D is offline
Find More Posts by Tommy D
Hooper, full throttle!
Tommy D's Avatar
USA, NY, East Islip
Joined Feb 2004
11,083 Posts
Quote:
Originally Posted by cryhavoc38 View Post
Charles,
I was actually using this last night while doing a storage discharge on some lipo's that weren't going to be used for the next few days. I had the receiver with me in my office here, so I could watch the cell displays slowly go down. Its like my wireless thermometer for the bbq.

Wow... thats a interesting idea.

I am to assume you have the load pulling only on the 12V leads? By that I mean my charger also doubles a s a discharger. However the "highest" state of discharge is 3.6 VPC. So normally I let it run down to 3.6, then I charge back to 3.85.

Point I'm making is the balance connector is employed by the charger dis-charger. I wonder if I could make a "Y" connector between them to watch the state of discharge.

Tommy D
Tommy D is offline Find More Posts by Tommy D
Reply With Quote