View Single Post
Old Jan 30, 2010, 02:31 PM
FanTasticModels is offline
Find More Posts by FanTasticModels
Registered User
Southlake, Tx
Joined Apr 2002
371 Posts
Guys,
I had no idea this event would blast off like this. And , it has caused us to tighten up the air frame more quicky than expected. So, here additions and clarifications:

1)Spinner diameter should represent the full size version . Slightly smaller is acceptable.
2)Non- scale protubrances can not be used to meet dimentions.
3)Main wheels shall be 2.5 inches in dia with a hub width and tire width of no less than .700.
4) Wheel pants will be required if found on original and shall be no thinner than 1 inch at axle area.
5)Cheek cowls shall a min 5/8 inch radius at widest point and represent the shape of originals at the front ,middle, and rear. The plan view across both cowls shall be no less than 4.25 inches.
6)Any chin scoops will be represented as in the original.
7)Canopies have to have a min outside radius of 5/8in at the pilot's head area and a min 1.825 in at unfilleted base of canopy. Canopy must represent shape of original version both front and back.

jerry small
jerry@jerrysmallcreations.com
FanTasticModels is offline Find More Posts by FanTasticModels
Reply With Quote