View Single Post
Old Jan 25, 2010, 08:19 PM
rctimer is offline
Find More Posts by rctimer
rctimer's Avatar
Hong Kong, Pok Fu Lam
Joined Sep 2009
637 Posts
Quote:
Originally Posted by Bombay View Post
So far I have ordered 10+ of the 2212-6 and 2826-6 motors.

I just received a new order this past Friday. This time around, two out of 3 of the 2826-6 motors (with the swirl bell) have magnets protruding from the bottom of the bell. This is not good. Often, it is an indication that the magnets slipped before the glue dried. It can also be a sign of delamination (glue failure). These are brand new...have not been run yet. Not good. See picture below. I wonder if RCTimer would send me new ones?

We also had an in-flight failure of one of the 30A programmable ESC's. We did a pre-flight test...and the motor 2826-6, prop 6x4, and battery were only pulling ~21 amps at full throttle. It caught on fire about mid-flight. We lost a plane, the esc, the motor, the battery, the Spektrum receiver, servos, etc. Not good. You can read about that here.
http://www.rcgroups.com/forums/showp...postcount=1424
Dear Bombay,

Sorry for any inconvenience.
This is a quality problem, please don't worry, can you tell me how much motor is fault, we can resend new to you ASAP.
Deeply appreciate for your forgiveness.
Thank you much !

Nina
rctimer is offline Find More Posts by rctimer
Site Sponsor
Latest blog entry: SKYZONE 3D FPV Goggles V2
Reply With Quote