View Single Post
Old Jan 12, 2010, 10:42 PM
Traekerouac is offline
Find More Posts by Traekerouac
Registered User
Joined Dec 2009
30 Posts
Actually, when I connect the USB to the computer I don't get any information about the charge occuring so I'm not sure if the charge is happening. This is why I wanted to register the product. The charger itself doesn't tell me that it's charging in some obvious way either, I don't see a "live mode" that tells me it's current voltage and ampage, I feel like a retard but I guess this means it's not charging then?

I'm using stock NiMH 8.4V 3000 mAh batteries and I created a pre-set for them with the target volts and amps to be the same as listed above. I hold down the start button and it says it loads but I don't see any useful information after this about the charge actually happening.
Traekerouac is offline Find More Posts by Traekerouac
Reply With Quote