Thread: Discussion Hitec Aurora 9 Transmitter
View Single Post
Old Dec 26, 2009, 06:24 PM
A.T. is offline
Find More Posts by A.T.
Registered User
Joined Aug 2002
5,811 Posts
Aurora 9 - Throttle Curve - Throttle Expo & P-Mix Setupt-Up

Quote:
Originally Posted by Devil_Inside View Post
Thank you, Mike. I also have another question for you -
How can I setup exponential on the throttle?!?
In the D/R & EXPO menu I can select everything BUT the throttle, and if I go to T. CURVE
I can enable Exponential, but I can only set exponential on Point-1 -
how do I select a different point as I want to set my exponential around the middle?!? Thanks!
1. Throttle Curve:
When setting the Throttle curve, move Throttle stick to point 4 (points 1-7) on the line shown on screen
or to where you want the Expo to activate and then simply use (-) key to reduce to say 10-25% as per pictures attached.
A switch could also be assigned so as to revert to normal throttle if and when required.

2. Throttle-Elevator P-Mix:
. Throttle-Elevator P-Mix to increase elevator as throttle increases.
quote:
"use P-mix 6,7, or 8 they have a 7-point curve so you can fine tune it better for multiple throttle positions.
e.g. P-mix 8 to mix THRO to ELEV, note these are functions, not channels.

Caution for ex JR/Spektrum users:
Hitec Transmitters Use MINUS (-) Expo on all controls where you would have used PLUS Expo on JR/Spektrum TX.

. Aurora 9ch - Video - Helicopter Set Up - Finless Bob's Review Tips and how To - Series - New (Throttle Curve x 1 & Gyro x 2) added 23Dec10.

Alan T.
Alan's Hobby, Model & RC FAQ Web Links
A.T. is offline Find More Posts by A.T.
Last edited by A.T.; Dec 19, 2012 at 02:04 PM. Reason: Change url x 1
Reply With Quote