View Single Post
Old Oct 12, 2003, 09:24 PM
BQuick is offline
Find More Posts by BQuick
Registered User
Joined Jun 2002
663 Posts
Graham,

The wings are solid. I cut two templates out of wood and used them with the hot wire to cut the cores. They are 9/16" thick.

I understand how skidding might make it want to roll, but I can't figure out why it would want to dive. I was trying to do knife edge, but when I got it rolled on it's side and applied rudder, it acted as if I had applied down elevator. It may be that my tail section is too small since I think it's actually to scale. I'll have to try it in less wind.

- Brad
BQuick is offline Find More Posts by BQuick
Reply With Quote