Thread: Discussion A 1M Zone Wing
View Single Post
Old Nov 13, 2009, 12:51 AM
Berrie is offline
Find More Posts by Berrie
Festina lente
Berrie's Avatar
Schoonhoven, the Netherlands
Joined May 2006
245 Posts
Quote:
Originally Posted by GaryO View Post
Berrie,

Wont the extra thick templates (1" steel) really cool the wire?

Gary
I think I wasn't very clear a few posts ago. We will make two kind of templates:

1) Weights to hold the foam on the workdesk
2) Templates for cutting the wing (foil)

These 1"templates are ment to put ON the foamblocks to keep them flath on the workdesk. There will be at least 15mm foam between the cutting wire and the weights.

The cuttingtemplates, at the sides of the foamblocks, shall be made of 0.4mm thick stainlesssteel or whatever there is for free.

"sadly" both the laser and acetyleen/oxygen cutters have a lot "real" work to do. So we have to wait. (Economical revival started one week to early...)
Berrie is offline Find More Posts by Berrie
Last edited by Berrie; Nov 13, 2009 at 01:01 AM.
Reply With Quote