View Single Post
Old Nov 12, 2009, 08:01 AM
vinmech is offline
Find More Posts by vinmech
Old skool speed freak!
vinmech's Avatar
Napa, Ca
Joined May 2004
697 Posts
Quote:
Originally Posted by littleoak View Post
So I removed the old motor. Put on a new one, same model, re-bound spektrum and reset esc end points. New motor works just fine, so not ESC.

Pulled old motor apart and I cannot see anything (see pic) however, when I connect it up it tries to run but very jerky. All connections look good, no loose magnets, the motor spins freely by hand. So I am at a loss. Any thoughts out there?
put a VOM on the leads and check resistance, check between all leads-should be very low resistance and pretty much equal between each other.
Then check each lead to metal frame, you should not read anything here on all three leads. Should read as open. You get anything there, that's your problem!

Hope that helps

Mikeeee
vinmech is offline Find More Posts by vinmech
Reply With Quote