View Single Post
Old Nov 12, 2009, 07:20 AM
littleoak is offline
Find More Posts by littleoak
Goats & Glocks Eat Anything
littleoak's Avatar
Houston, in the Great State of Texas
Joined Jan 2009
459 Posts
So I removed the old motor. Put on a new one, same model, re-bound spektrum and reset esc end points. New motor works just fine, so not ESC.

Pulled old motor apart and I cannot see anything (see pic) however, when I connect it up it tries to run but very jerky. All connections look good, no loose magnets, the motor spins freely by hand. So I am at a loss. Any thoughts out there?
littleoak is offline Find More Posts by littleoak
Reply With Quote