Thread: New Product Fancy Foam MX2 by RJ Gritter
View Single Post
Old Oct 30, 2009, 02:38 PM
Jerry Combs is offline
Find More Posts by Jerry Combs
is it flying time?
Jerry Combs's Avatar
Wyandotte Oklahoma
Joined Oct 2004
2,777 Posts
Quote:
Originally Posted by Azarr View Post
I lock the surface in place using these simple jigs, that way they're always centered when you heat shrink the last piece. The strange material is something called balsa that we used in another life.

Azarr
I too use a jig very much like this one, I still ended up with a slight (less than 1/32") sag in my surfaces. I need to make a new jig to allow for this or find a better way of bending my Z-bends to make them a little closer fitting.
Jerry Combs is offline Find More Posts by Jerry Combs
Reply With Quote