View Single Post
Old Oct 20, 2009, 01:53 AM
SteveT. is online now
Find More Posts by SteveT.
I fly, therefore, I crash!!!
SteveT.'s Avatar
San Jose, CA
Joined Jan 2008
31,949 Posts
Discussion
Boosted end points, VS. longer servo arms..

Hi Guys...

A quick question for you.

The plane in my avatar is an Aero-Works .90-1.20 size Yak 54 that I have converted to electric power. It flies great, but it lacks in rudder authority. I have the pull-pull cables hooked to the inner holes on the control arms on the rudder, and on the outer holes on the longest arms that came with the Hitec HS-7985MG digital servos (essentially the same length as the Dubro long arms for these servos).

Today, I was checking the throw on the rudder, and found that the end point adjustments were set to 100$, but with my JR X9303, I can set them higher. I set them up for 145%, and get a lot more throw on my rudder, however, I am getting a fairly pronounced buzz at the extreme ends of the throw. Or, I also have some longer carbon fiber extended servo arms that I can use.

In your opinions, which way is better?? to over drive the servos, or to use the extended arms??

Thanks in adavance...

SteveT
SteveT. is online now Find More Posts by SteveT.
RCG Plus Member
Latest blog entry: My hangar...
Reply With Quote