View Single Post
Old Oct 12, 2009, 06:35 PM
GeneR is offline
Find More Posts by GeneR
Registered User
Lake City, PA USA
Joined Sep 1999
336 Posts
Well,

The wind died down to 5 this evening so I took my plastic kit out for the maiden flight. A quick check of the controls and she jumped of the ground and settled into a rock-steady 3 foot hover. Three clicks on the tail and I shot around for a dozen circuits to check out the trim. I will need to tweak the linkages later but it flies wonderfully. Very nice, smooth flyer. Note I never wanted a 3d machine but just something to fly around the backyard and it is clear this will fill the bill nicely. I could not be more pleased.

Setup:
HK250 base plastic kit, all stock
3 HTX900 on cyclic
1 Spektrum programmable 6g digital servo on the tail (in tail mode)
E-Flite 11g gyro
Turnigy 25amp ESC
Turnigy 2623 3000kv motor
Spektrum AR6100E rx
Turnigy 800mah 3 cell batt

Gene
GeneR is offline Find More Posts by GeneR
Reply With Quote