Thread: Mini-HowTo wot trainer
View Single Post
Old Oct 10, 2009, 08:45 AM
MCarlton is offline
Find More Posts by MCarlton
Registered User
Cromer,Norfolk, UK
Joined Nov 2006
2,505 Posts
Pinning refers to a method of securing the hinges. When the hinges are glued into position in the control surface and the wing, drill two small holes vertically through the wing (and thus through each hinge) and then glue a length of cocktail stick or similar through the holes and cut off flush with the wing surface.

Do the same on the aileron.

This then stops (or helps to stop) the hinges from pulling out.
MCarlton is offline Find More Posts by MCarlton
Reply With Quote