Thread: Build Log Passer X
View Single Post
Old Sep 30, 2009, 08:14 AM
yaitsfast is offline
Find More Posts by yaitsfast
Is everyone from California?
yaitsfast's Avatar
Orange County, NY
Joined May 2007
234 Posts
If the prop is too stiff, just loosen up on the screws that attach the blades a smidge. You might want to remove them, apply some threadlock and then set the tension. A little CA on the screwhead after setting the tension would also keep them from loosening up. Just be careful not to get any down the hole or the prop will never fold.
yaitsfast is offline Find More Posts by yaitsfast
Reply With Quote