View Single Post
Old Sep 30, 2009, 04:11 AM
Kiof is offline
Find More Posts by Kiof
-.-
Kiof's Avatar
Tarifa, Spain
Joined Nov 2007
153 Posts
Bill Thank you very much for the last updates, I try just now the rssi with the DMD 869 LRS system and it work perfect without touch any ressistor, just I plug the rssi cable to the middle pin of temp 1.

But I have one issue, after make all the process for the RTH in the safe menu wizard correctly.

when I turn off the transmitter I don't get the message of failsafe detected, I gete a message say "RTH active (or some thing like that) bad rx pulses detected" (or some thing similar).

My question is if this message will turn ON the RTH or I need to get the other message (the failsafe detected one)

I think the reasson is because the pulses of the LRS RX, because in the beggining if I configure the ATV for 100% the channels to access and select menu & items in the OSD menú don't work. I must to Put the ATV in the TX in 44% to work propertly.

what do you think about that.

Thanks in advance (and like allways... sorry for my english hope you can understand)

Best regards
Kiof is offline Find More Posts by Kiof
Last edited by Kiof; Sep 30, 2009 at 04:36 AM.
Reply With Quote