View Single Post
Old Sep 26, 2009, 01:12 PM
Truglodite is offline
Find More Posts by Truglodite
Registered Aircraft Offender
Truglodite's Avatar
Carmichael, CA
Joined Feb 2007
3,546 Posts
...but the suffering was worth it indeed!

I finished testing my 16T. The result is good, however I didn't have a 12x6e on me. After playing with DCalc a bit, it looks like the 12x6e will perform similar to Manuel's 15/16T (page 5). APC 11x4.7sf looks even better if it can handle 7800RPM. I figured it looked like something worthy of a popular wind for this motor, so I wanted to share some 4-prop calcs with you all.

Unofficially:
DT750 16T-21awg-Delta
864Kv / Io = 1.92A / Rm = 0.0836 ohm

FWIW, I did end up getting true 4mm hardware. The 4mm nuts I got at Ace fit perfectly in the GWS HD hub socket. Also, my mechanics sounded pretty clean; not like a coffee grinder anyways.

Cheers,
Kev

ps: I included 2 pics for those in to motor pr0n. Perhaps there's enough room for 20.5awg?

...and that's no typo, it did pork up to 86gm with all that copper (includes nuts, washers, and connectors... no mount)!
Truglodite is offline Find More Posts by Truglodite
Last edited by Truglodite; Sep 26, 2009 at 01:19 PM.
Reply With Quote