Thread: Discussion New: Multiplex Acro Master
View Single Post
Old Sep 03, 2009, 11:42 AM
SonyVegasUser is offline
Find More Posts by SonyVegasUser
currently 3D-Dabbler
SonyVegasUser's Avatar
Richmond, VA
Joined Aug 2009
177 Posts
Quote:
Originally Posted by TexasFlyer
I did the skewer thing like Gene but with some spar CF rods and have had great luck with it. After you've push the skewer through the foam, I'd suggest stiffining up the foam holes with some thin CA, much like people do with servo screw holes in balsa. Otherwise, these foam holes will begin to enlarge. The CA hardened them and this setup works great and is easy to install/deinstall.

Alan
I was planning on going the CF route as well. However, I was walking outside to put the plane in the air and I was too impatient to go back inside and cut the rod that was sitting on my desk.

I was standing next to a bucket of dry wall screws and thought.... hmm... this will get me in the air faster. I should probably go back and replace the screws with the CF rod
SonyVegasUser is offline Find More Posts by SonyVegasUser
Reply With Quote